Technical specifications 760
CBAC SR 760
SB SR 760
SBS SR 760
CBAC CR 760
SB CR 760
SBS CR

Power supply 230 V ~ (+6% -10%) 50 (60) Hz

Electric motor Single-phase, bi-directional

Thermal protection on motor winding 120°C

Motor rotation speed 1400 rpm 960 rpm 1400 rpm rpm 960 rpm


Absorbed power 220 W

Absorbed current 1 A

Effective torque 0÷543 Nm 0÷272 Nm 0÷543 Nm Nm 0÷272 Nm


Angular velocity 7,8°/s 5,2°/s 7,8°/s 5,2°/s


Operating ambient temperature -20°C +55°C

Weight with oil 13 kg

Type of oil FAAC OIL XD 220

Rotation maximum angle 162° 148°


Protection class IP 67

Deceleration angle - 10°


Degree of deceleration - adjustable


Dimensions


Technical specifications of casing
• in pressure-cast aluminium, NIPLOY treated transmission shaft,
two radial bearings and one thrust bearing.
Electronic control equipment
Model Specifications
410 MPS Vedi riferimenti

450 MPS Vedi riferimenti

460 P Vedi riferimenti


N.B.: Timed electronic deceleration is possible by using the 460 P equip-ment. By combining the device with GATECODER, in addition to electronic deceleration, the electronic obstacle detection function is also available.

SPECIFICATIONS
Integrated hydraulic operator consisting of pump unit and jack • Hydraulic pump unit models with hydraulic locking on opening and closing and without hydraulic locking • Models suitable for max leaf length up to 4 m • Leaf max weight 800 kg • Models with leaf max opening angle 162° and 148° • Models with max use frequency 30 and 55 cycles/hour • Models with max torque 272 Nm and 543 Nm • Models with angular velocity 5.2°/s and 7.8°/s • Electric motor power supply 230 V (+6% -10%) - 50(60) Hz • Electric motor power 220 W • Thermal protection at 120°C built into motor winding • Operating ambient temperature -20°C +55°C • Protection class IP67 • Release device with triangular or customised key (optional) accessible both from inside and outside • Single-phase motor with two rota-tion directions • Hydraulic gerotor pump (max low noise) • Models with pump flow rate 0.5 l/min and 0.75 l/min • Die-cast distribution flange • Separate control of opening and closing force by by-pass valves • Anti-crushing safety to UNI 8612 Standards • Tank in anodi-sed aluminium • Rack piston and jack • Die-cast aluminium jack body • NIPLOY treated jack liner • Mineral hydraulic oil with additives Casing • Casing in aluminium with cataphoresis treatment and cover in stainless steel • Drain pipe and electric cable holes • NIPLOY-treated integrated transmission shaft • Radial bearings and thrust bearing • Dimensions (Length x Width x Height) 490 x 260 x 159 mm