Technical specifications 400
CBC 400
CBAC 400
SB 400
SBS 400 CBACR 400
CBAC LN 400 SB LN

Power supply 230 V~ (+6% -10%) 50 (60) Hz

Absorbed power 220W

Absorbed current 1 A

Motor rotation speed 1400 rpm

Rod extension speed 1 cm/s 0,75cm/s 1,5 cm/s


Pump flow rate 1 cm/s 0,75cm/s 1,5 cm/s


Traction and thrust force 0÷620 daN 0÷775daN 0÷465 daN


Operating ambient temperature -20°C +55°C

Thermal protection on motor winding 120°C

Weight 8,6 kg

Type of oil FAAC OIL XD 220

Protection class IP 55

Dimensions


Electronic control equipment

Model Specifications

410 MPS Approfondimento

450 MPS Approfondimento

460 P Approfondimento


N.B.: Timed electronic deceleration is possible by using the 460 P equip-ment.
By combining the device with GATECODER, in addition to electronic
deceleration, the electronic obstacle detection function is also available.


SPECIFICATIONS
Hydraulic operator with piston for swing-leaf gates • Models available with hydraulic locking on closing, opening and closing, and without locking • Models suitable for max leaf length up to 7 m • Models with max use frequency up to 50 cycles/hour • Models with max traction/thrust force up to 775 daN • Models with rod extension speed 1 cm/s and 1.5 cm/s • Models with pump flow rate of 0.75 - 1 - 1.5 l/min • Models with rod effective stroke 280 mm and 380 mm • Pillar installation • Leaf opening inwards or outwards • Max opening angle 120° • Electric motor power supply 230 V (+6% -10%) - 50 (60) Hz • Electric motor power 220 W • Thermal protection at 120°C built into motor winding • Overall dimensions (Length x Width x Height) 1.031x90x113 mm • Protection class IP 55 • Operating ambient temperature -20°C +55°C • Built-in release device with customised key • Single-phase motor with two rotation directions (1.400 rpm) • Hydraulic gerotor pump (max low noise) • Die-cast distribution flange • Separate control of opening and closing force by by-pass valves • Anti-crushing safety to UNI 8612 standards • Rod in stainless steel • Securing to front fitting by ball joint • Tank and piston protective housing in anodised aluminium • Air breather screw • Mineral hydraulic oil with additives